SIMPLE DIRECTIONS FOR LOG BOSS
Pressure wash entire surface with minimum 2800 psi.
Carefully wipe or wash off all sawdust residue from logs and surrounding surfaces; eg, window frames, gutters, downspouts, etc.
Prior to application, pressure wash entire surface to remove any dirt or residue.
Before using always stir stain thoroughly. Apply by either:
Pre-dipping wood prior to construction will provide optimum protection.
Spraying (either low-pressure or airless) by flooding the surface to maximum absorption and back roller or wipe with damp towel immediately.
To obtain maximum protection a minimum of 3 applications is recommended.
Unless a varnished appearance is desired, do not apply in direct sunlight or in the heat of the day.
Do not apply if rain is likely to occur soon after application.
Clean hands and tools with soap and water
To retain a quality appearance, the surface should be cleaned with a pressure washer. Apply with additional LOG BOSS as necessary. A high degree of protection will remain regardless of appearance, due to previous applications of LOG BOSS that have bonded with the cellular structure of the wood.
Weather-Bos products will have an average coverage between 50 to 100 sq. ft. (4.7-9.29 sq. ms.) per U.S. gal. on each application depending upon surface and conditions.
If swallowed, drink milk or warm water, induce vomiting and call a physician.
This product complies with all California and Federal V.O.C. limitations.